My Projects

LCD module data

Numeric

Character

Mixed

Graphic

Resources

This is an old revision of the document!


IP230

LCD Description
ModelIP 230
ManufacturerShoretel
Recovered fromShortel IP 230 Phone
Board IDsA270-1051-02 rev A, C2C084793
Board IDsKEPC-945-E, EveryMan LCDBoard May 281)
LCD typepositive
Polarizer typerefective
Columns141 pixels (27 characters)
Rows44 pixels (5 rows)
Char matrix5×8
Driver IC
Backlight-
Arduino driver
Connectorribbon cable
Num Pins35
Pin spacing2 mm
LCD size86 mm x 52 mm
Connector pin-out2) Arduino test rig
Pin#MeasuredLabelPincolour
1VssGND
21200
31200
41200
5
6
7
8
9
10
111040
121040
131040
141040
151040
161040
171040
181200
19870U4 pin 1
20870U4 pin 8
21VssGND
22900
23900
24900
25820
26820
27865
28865
29865
30865
31865
32865
33865
34865
35Vdd3V



The display has approximately 141 columns and 44 rows of pixels (plus a few extra as part of a vertical dividing line). But, as can be seen in the pixel layout photo below, those pixels have a rather custom layout which will make it interesting to drive, and probably not worth the effort! Despite apparently being a graphic, rather than character display, the pixels are physically separated into blocks. In the upper half of the display we have 4 blocks 11 pixels wide, 18 blocks 5 pixels wide and one block 7 pixels wide. These are in 3 rows, 8 pixels high, with a gap between the rows. So you could treat the upper half as 3 rows of 27 characters, with a small aberration where the 7 pixel wide block is. The lower half is even stranger, with one blank row, one row as above, then a last row divided into 24 character blocks with borders grouping sets of 6 characters. Not exactly general purpose!

Similar to A270-1101-01, D2C400460, SEVG LCD Board, from other IP 230G phones, but they have 39 pins - ShoreTel 230G telephone from 2011


Examples :

1)
Phone 11 Oct 2006
2)
connector not labeled on board, so this is looking at the back of the upright LCD, numbering from left to right