LCD module data
Numeric
Character
Mixed
- ≡ Uniden FP203 ✘
- ≡ Uniden FP204 ✘
- ≡ VIP89Z G-Code ✘
Graphic
key: ≡ parallel, ↔ serial, ~ LVDS, _ unknown, ✘ discarded as not useful
Resources
This is an old revision of the document!
| LCD Description | |
|---|---|
| Model | G64128W01 |
| Manufacturer | Crystal Clear Technology |
| Recovered from | - |
| Board IDs | |
| LCD type | |
| Polarizer type | |
| Columns | |
| Rows | |
| Char matrix | |
| Driver IC | |
| Backlight | - |
| Arduino driver | |
| Connector | |
| Num Pins | |
| Pin spacing | “ |
| Module size | mm |
| Connector pin-out | Arduino test rig | |||
|---|---|---|---|---|
| Pin# | IC pin | Label | Pin | colour |
| 1 | VSS | Ground terminal of module | ||
| 2 | VDD | Supply terminal of module | ||
| 3 | VO | Power supply for Liquid Crystal Drive | ||
| 4 | RS | Register select signal | ||
| 5 | R/W | Read/Write selection: High = Read, Low = Write | ||
| 6 | E | Enable signal | ||
| 7 | D0 | Bi-directional Data Bus | ||
| 8 | D1 | Bi-directional Data Bus | ||
| 9 | D2 | Bi-directional Data Bus | ||
| 10 | D3 | Bi-directional Data Bus | ||
| 11 | D4 | Bi-directional Data Bus | ||
| 12 | D5 | Bi-directional Data Bus | ||
| 13 | D6 | Bi-directional Data Bus | ||
| 14 | D7 | Bi-directional Data Bus | ||
| 15 | CS1 | Select IC U2 (active high) | ||
| 16 | CS2 | Select IC U3 (active high) | ||
| 17 | RSTB | Reset signal (active low) | ||
| 18 | VOUT | * Negative voltage from the LCD Module | ||
| 19 | SLA | Backlight power supply | ||
| 20 | SLK | Backlight ground | ||
—-
Examples :
electronic/lcd/g64128w01.1646557927.txt.gz · Last modified: 2022/03/06 09:12 by tony
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International