key: ≡ parallel, ↔ serial, ~ LVDS, _ unknown, ✘ discarded as not useful
This is an old revision of the document!
LCD Description |
|
|---|---|
| Model | 4035 |
| Manufacturer | Alcatel |
| Recovered from | Alcatel Anthracite 4035 |
| LCD type | positive |
| Polarizer type | reflective |
| Columns | 40 |
| Rows | 2 |
| Char matrix | |
| Driver IC | NT3881DFG-52, ST7063C-QG |
| Backlight | - |
| Arduino driver | |
| Connector | |
| Num Pins | |
| Pin spacing | |
| Pin# | IC pin | Label | Pin | colour |
|---|---|---|---|---|
| 1 | ||||
| 2 | ||||
| 3 | ||||
| 4 | ||||
| 5 | ||||
| 6 | ||||
| 7 | ||||
| 8 | ||||
| 9 | ||||
| 10 | ||||
| 11 | ||||
| 12 | ||||
| 13 | ||||
| 14 | ||||
| 15 | ||||
| 16 | ||||
| 17 | ||||
| 18 | ||||
| 19 | ||||
| 20 | ||||
The phone had 3 LCD panels, one was a 40×2 alphanumeric LCD, the other two displayed two rows of bar icons. All LCDs are connected to the main board via conductive rubber strips, so difficult to use elsewhere. The LCD drivers appear to run off 5V, not sure were that is regulated on the board.
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International