My Projects

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

robotic:tumbler [2021/07/08 17:17]
tony
robotic:tumbler [2022/09/18 21:53] (current)
tony
Line 38: Line 38:
 The electronics is a single board (WB-1407R) containing an RX-2B remote control receiver chip, aerial circuitry, ​ and a bridge of eight transistors (4x HY33 A1300, 4x AE9T) to drive the motors. ​ There is also a fuse on the power line. The electronics is a single board (WB-1407R) containing an RX-2B remote control receiver chip, aerial circuitry, ​ and a bridge of eight transistors (4x HY33 A1300, 4x AE9T) to drive the motors. ​ There is also a fuse on the power line.
  
-{{:​robotic:​tumbler:​p5025474a.jpg?​300|Circuit board top}} {{:​robotic:​tumbler:​p5025467a.jpg?​300|Circuit board bottom}}+{{:​robotic:​tumbler:​p5025474a.jpg?​300|PCB top}} {{:​robotic:​tumbler:​p5025467a.jpg?​300|PCB bottom}}
  
 The remote control is powered by a nine volt battery, and has an on/off switch, left & right motor forward/​backward switches, and a turbo pushbutton switch. ​ The remote control is powered by a nine volt battery, and has an on/off switch, left & right motor forward/​backward switches, and a turbo pushbutton switch. ​
Line 46: Line 46:
 All the electronics are on one small board which has the switches mounted directly on it.  There is one 27.145MHz crystal, one power-on LED, and a TX-2B remote controller transmitter IC. All the electronics are on one small board which has the switches mounted directly on it.  There is one 27.145MHz crystal, one power-on LED, and a TX-2B remote controller transmitter IC.
  
-{{:​robotic:​tumbler:​p5025460a.jpg?​300|Remote ​circuit board}}+{{:​robotic:​tumbler:​p5025460a.jpg?​300|Remote ​PCB}}
  
 ====== References and Additional Resources ====== ====== References and Additional Resources ======