Differences
This shows you the differences between two versions of the page.
|
electronic:lcd:dect1535 [2019/11/24 22:06] tony |
electronic:lcd:dect1535 [2022/09/02 21:37] (current) tony |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| ^ Connector pin-out ||^ Arduino test rig | | ^ Connector pin-out ||^ Arduino test rig | | ||
| ^Pin#^Label^Description ^Pin| | ^Pin#^Label^Description ^Pin| | ||
| - | ^1| | + | ^1|Vdd?|3.2V| |
| - | ^2|Gnd| | + | ^2|Gnd|0V (battery -ve)| |
| - | ^3| | + | ^3| |25mS square wave 0V to -3.3V| |
| - | ^4|3.3V| | + | ^4| |25mS square wave 2V to 5.5V| |
| ^5| | ^5| | ||
| | |||| | | |||| | ||
| - | ^6| | + | ^6|Reset?|0V jumps to 3.2V after short delay on power-up| |
| - | ^7|Clock (200khz)| | + | ^7|CLK|Clock (200khz) present when clocking data| |
| - | ^8|Data| | + | ^8|Data|Data, on rising edge of Clock, 8bits, MSB first| |
| - | ^9|CS| | + | ^9|CS|Chip select, active low, for duration of data| |
| - | ^10|RS ?| | + | ^10|RS|Register select, Low = command, High = data| |
| \\ | \\ | ||
| \\ | \\ | ||
| + | |||
| + | ---- | ||
| + | ===== Datasheets ===== | ||
| + | * {{:electronic:lcd:uniden_dect1535_lcd.pdf|LCD initialisation sequence that works for this LCD}} | ||
| + | * {{:electronic:lcd:uniden_dect1535_lcd.sr|LCD initialisation sequence in sigrok format}} | ||
| ---- | ---- | ||
Page Tools
electronic/lcd/dect1535.1574586399.txt.gz · Last modified: 2019/11/24 22:06 by tony
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported