Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| electronic:lcd:dect1535 [2026/09/01 09:10] – tony | electronic:lcd:dect1535 [2026/09/26 05:51] (current) – tony | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | {{ : | ||
| + | ^ LCD Description | ||
| + | ^Model|**DECT1535**| | ||
| + | ^Manufacturer|Uniden| | ||
| + | ^Recovered from|[[: | ||
| + | ^Board IDs|PE-2358BA| | ||
| + | ^LCD type|positive| | ||
| + | ^Polarizer type|transflective| | ||
| + | ^Columns|16| | ||
| + | ^Rows|3| | ||
| + | ^Char matrix|5x7| | ||
| + | ^Driver IC|| | ||
| + | ^Backlight| | | ||
| + | ^Arduino driver|| | ||
| + | ^Connector|pins| | ||
| + | ^Num Pins|10| | ||
| + | ^Pin spacing|" | ||
| + | |||
| + | ^ Connector pin-out | ||
| + | ^Pin# | ||
| + | ^1|Vdd? | ||
| + | ^2|Gnd|0V (battery -ve)| | ||
| + | ^3| |25mS square wave 0V to -3.3V| | ||
| + | ^4| |25mS square wave 2V to 5.5V| | ||
| + | ^5| | ||
| + | | |||| | ||
| + | ^6|Reset? | ||
| + | ^7|CLK|Clock (200khz) present when clocking data| | ||
| + | ^8|Data|Data, | ||
| + | ^9|CS|Chip select, active low, for duration of data| | ||
| + | ^10|RS|Register select, Low = command, High = data| | ||
| + | |||
| + | \\ | ||
| + | ---- | ||
| + | ===== Additional info ===== | ||
| + | * {{: | ||
| + | * {{: | ||
| + | |||
| + | \\ | ||
| + | ---- | ||
| + | ===== Examples ===== | ||
| + | |||
| + | {{: | ||
| + | / | ||
| + | |||
| + | {{: | ||
| + | |||
| + | {{: | ||
| + | / | ||
| + | / | ||
| + | |||
| + | {{: | ||
| + | |||
| + | {{: | ||
| + | / | ||
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International